Explore Arduino electronics with an UNO R3 board, breadboards, sensors, motors and displays. This advanced starter kit brings together components for learning programming, reading sensor inputs and controlling project outputs.
Projects to explore
- LED blinking, traffic lights and PWM brightness control
- Distance and temperature sensing with the HC-SR04 and LM35
- Servo and stepper motor control
- LCD1602, seven-segment and LED dot-matrix displays
- Joystick, keypad and infrared remote inputs
Package contents
- 1 x UNO R3 board
- 1 x USB cable, 30 cm
- 1 x extension board with mini breadboard
- 1 x 4 x 4 membrane keypad
- 1 x HC-SR04 ultrasonic distance sensor
- 1 x 830-point breadboard
- Assorted 5 mm LEDs: 10 red, 10 green, 10 yellow, 5 white and 1 RGB
- 1 x 74HC595 shift register
- 1 x MAX7219 IC
- 2 x 5 V buzzers: 1 active and 1 passive
- 1 x single-digit seven-segment display, common anode
- 1 x four-digit seven-segment display, common anode
- 10 x 12 x 12 mm push buttons
- 5 x 6 x 6 mm push buttons
- 1 x light-dependent resistor
- 20 x 10 kOhm resistors
- 20 x 220 Ohm resistors
- 5 x 1 kOhm resistors
- 1 x 5 kOhm trimmer potentiometer
- 1 x 10 kOhm trimmer potentiometer
- 1 x LM35 temperature sensor
- 1 x LCD1602 display
- 1 x PS2 joystick module
- 1 x 5 V stepper motor
- 1 x stepper motor driver board
- 1 x SG90 servo motor
- 1 x RGB module
- 65 x jumper wires
- 10 x female-to-female Dupont wires
- 1 x 2.54 mm straight 40-pin header
- 1 x 2.54 mm right-angle 40-pin header
- 1 x mercury tilt switch
- 1 x flame sensor
- 1 x infrared transmitter
- 1 x infrared receiver
- 1 x remote control
- 1 x 8 x 8 LED dot-matrix display
- 1 x 5 V, 10 A relay module with optocoupler
- 1 x 9 V battery connector cable
CR2025 battery for the remote and 9 V battery are not included.